We received our new print bed from eBay/China. Not a Lokbuild but at least its cheaper. First thing I noticed is that this sheet is thicker than a Lokbuild, 0.6mm thick instead of 0.5. When I followed the steps on calibrating I clicked
6 8 times to ensure proper spacing instead of the original 4.
1. Launch AutoMaker software and navigate to Calibration button
2. Follow instructions until asked to insert paper between nozzles and build plate
3. Follow instructions and raise nozzles to point at which paper moves freely between nozzles and build plate
4. Set height
4 6 8 clicks higher than this point (i.e. 0.4 mm)
5. Proceed as normal